| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0195 00
ASSEMBLY (continued)
14. Install the valve seat (36), check ball (35), and spring (34). Install the hex plug (32) with a new O-ring (33).
15. Install the Woodruff key (8) in the drive shaft (9) and check for free rotation of the drive shaft.
16. Install the pump assembly (1) drive shaft (9), with the Woodruff key (8) in place into the drive assembly (4).
17. Secure both assemblies with the bolts (5), lockwashers (6), and nuts (7).
18. Ensure that distance "A" measures 2.594 inches (65.89 mm) before tightening the bolts (5).
19. Install the setscrew (3) and pipe plug (2) in the drive assembly (4).
ADJUST
1.
Install the pump on the propulsion engine from which it was removed (WP 0086 00).
2.
Remove the lockouts and tagouts and start the engine served by the pump.
3.
Remove the unloading valve cap (15) to gain access to the adjusting screw (16).
4.
Use a screwdriver to turn the adjusting screw (16) clockwise to increase the setting or counterclockwise to decrease the
setting. Set the adjusting screw for the pump to unload at 3000 lb/in, as observed on the accumulator pressure valves.
5.
Check the hydraulic fluid level in the reservoir. Replenish as required.
6.
Dispose of used hydraulic fluid, cleaning solvent, and contaminated materials in accordance with local regulations.
END OF WORK PACKAGE
0195 00-5/6 blank
0195 00-5
|
||
|
||
