| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0207 00
ASSEMBLY
1.
Lightly lubricate all parts with clean hydraulic fluid before installation.
2.
Install a new O-ring (19) and gasket (20) in the end cap cover (10).
3.
Thread the tie rods (23) into the end cap cover (10) if they were removed during disassembly.
4.
Install new piston ring packing (21) and O-ring (22) on the piston (9).
5.
Thread the piston (9) onto the piston rod (1) and secure it with the lockscrew.
6.
Install the rod packing (15) and packing retaining ring (14) into the head end cover (8).
7.
Install new O-rings (16 and 17) and gasket (18) into the head end cover (8).
8.
Install the rod wiper (11), bearing cartridge (12), and rod bearing (13) into the head end cover (8).
9.
Install the head end cover (8) onto the piston rod (1).
10. Install the cartridge retaining plate (7) on the head end cover (8).
11. Install the tie rod nuts (5).
12. Install the cartridge slug (4) and cartridge setscrew (3).
13. Install the stud (2) into the piston rod (1).
14. Dispose of used hydraulic fluid, cleaning solvent, and contaminated materials in accordance with local regulations.
END OF WORK PACKAGE
02070207 00-3
00-3/4 blank
|
||
|
||
