ASSEMBLE FINAL DRIVE ASSEMBLY

Custom Search

ASSEMBLY--PRIMARY DRIVE ASSEMBLY

TM-55-1905-242-14 Landing Craft Mechanized (LCM-8) (All Vessels with Mod 2 Applications) (ROHR Models) NSN 1905-01-465-7599 (EIC DWD) Manual

RAMP AND HINGE PINS, REPLACE

TM 55-1905-242-14

0216 00

ASSEMBLE FINAL DRIVE ASSEMBLY (continued)

Install the final planet assembly (10) so the planet gears engage in the internal teeth of the final drive housing (3) and the

splined bore of the planet hub (11) locates over the splined end of the drum (52). Tap the planet assembly into place until

it contacts the bearing that carries the drum in the final housing.

Install the thrust plate (9) in the end of the final planet assembly (10).

Lubricate the O-ring (8) with grease and install it in its groove in the end cover (6). Give the O-ring an additional coat of

grease.

Install end cover (6) in final drive housing (3) so that the filler plug (7) boss will be located at the bottom of the final drive

housing when the winch is mounted. Make sure that the end cover is properly seated against the gear teeth in the final

drive housing.

Install the snap ring (5) and make sure that it is properly seated in the bottom of the snap ring groove all the way around

the final drive housing (3).

Fill the final drive housing (3) with gear lubricating oil to the level of the filler hole and install the filler plug (7).

FOLLOW-ON PROCEDURE

Install the motor assembly as described in WP 0190 00.

END OF WORK PACKAGE

0216 0216 00-13

00-13/14 blank