| Tweet |
Custom Search
|
|
|
||
 TM 55-1925-204-12
d. Engine Electrical Starter.
(2) Installation. Reverse the procedures used
(1) Removal.
in removal to install the air cleaner, using a new
preformed packing for the air cleaner body.
(a) Tag and disconnect electrical leads
c. Fuel Filter. The fuel filter removes foreign matter
from the fuel before it enters the fuel pump.
(b) Remove
the
starter
mounting
(1) Removal. Shut off fuel supply to the
capscrews securing starter to the flywheel housing, then
disengage teeth of starter from the flywheel ring gear, and
engine, then remove fuel filter as follows:
lift starter from the engine. Remove gasket from flywheel
(a) Refer to figure 5-3, remove the two
housing and discard.
fuel lines.
(2) Installation.
(b) Remove
the
two
mounting
capscrews, then remove fuel filter from its mounting
(a) Position a new gasket on starter
bracket.
aperture in the flywheel housing, position the starter drive
into flywheel housing, then secure with the capscrews.
(b) Remove tags and install the electrical
NOTE
leads.
If engine is going in for overhaul,
e. Raw Water Pump. This pump supplies water to
remove the capscrews securing the
the heat exchanger.
mounting bracket, instead of those
(1) Removal. Shutoff fresh and raw water
securing fuel filter to the bracket .
supply to the engine (table 2-3). Then
proceed as follows:
(2) Installation.
(a) Loosen hose clamps (fig. 5-4) and
(a) Position fuel filter (and bracket) to
disconnect inlet and outlet raw water lines from the pump.
engine and secure with the capscrews.
(b) Install the two fuel lines.
(c) Open fuel line to the engine.
5-4
|
||
|
||
