| Tweet |
Custom Search
|
|
|
||
 TM 55-1925-204-12
Figure 5-8. Engine generator and voltage regulator.
(c) Loosen the generator adjusting bolt
If only replacing filter, remove drain plug from bottom of
and move generator toward' engine block, then lift the
adapter housing and drain the filter (fig. 5-8).
drive belt off the pulley.
(b) Tag and remove the two oil lines
(d) Remove the generator mounting
(inlet and outlet) from filter adaptor and engine block.
bolts, nuts, and lockwashers, then lift generator away from
(c) Remove the four capscrews and
the engine.
lockwashers securing the filter adaptor to the engine
(2) Installation. The generator and regulator
block, then lift filter away from the engine.
(2) Installation. Install the lubricating oil filter
are installed by reversing the procedures in step (1)
above.
by reversing the procedures in step (1) above.
k. Lubrication Oil Filter.
l. Exhaust Manifold ( Water Cooled ).
(1) Removal.
(1) Removal.
(a) Drain the engine lubricating system, if
(a) Drain the engine cooling system.
the engine is being torn completely down for repairs.
(b) Disconnect exhaust pipe from elbow
5-11
|
||
|
||
