| Tweet |
Custom Search
|
|
|
||
 (2) With linkage in place between governor and
throttle control has been removed from engine, or linkage has
throttle, loosen clamp bolt (3, fig. 5-47) in governor speed
otherwise been disturbed, governor linkage adjustment should
control lever (2). Using a screwdriver, turn shaft in lever hub
be checked to determine the correct positions of levers and
clockwise as far as possible.
shafts. Proceed as follows:
(1) Move hand throttle to RUN position.
1.
Subcap assembly-governor
4.
Governor case
2.
Lever-governor control
5.
Rod, governor subcap fuel
3.
Bolt-governor control lever
6.
Locknut
Figure 5-47. Adjusting fuel rod.
(3)
Tighten clamp bolt while holding shaft in
NOTE
position.
This step is not necessary on a governor
e. Fuel Rod Adjustment.
having subcap held in place by two Allen
(1) Loosen fuel rod locknut (6) and remove fuel
head screws.
rod knob.
(2) Turn locknut (6) so that fuel rod (5) extends
(2) Remove valve rocker cover.
1/16 inch beyond locknut.
(3) Loosen locknut (5, fig. 5-48) on maximum
(3) Replace fuel rod knob against locknut and
fuel adjusting (load limit) screw (6). Back screw out flush with
tighten locknut.
outer face of boss.
f. Position Injector Control Racks.
(1) With engine stopped, remove governor cover
and replace two screws through the subcap (1) and into the
governor case (4) to hold subcap in position.
5-60
|
||
|
||
