| Tweet |
Custom Search
|
|
|
||
 (b) Loosen cover clamps (1) and raise cover.
c. Purifier Bowl.
(c) Remove the cross pin from sleeve which
(1) General. The purifier bowl contains the primary
holds ball (24) in place, and check valve spring (25) and ball
parts of the purifier. The bowl is a centrifuge with many discs
(24) will drop out.
that revolve separating water and foreign substances from the
(4) Cleaning, inspection, and repair.
oil. For the purifier to function properly keep bowl clean.
(a) Clean all parts thoroughly in a dry-
(2) Maintenance and adjustment.
cleaning solvent which meets requirements of FED SPEC P-D-
(a) To clean bowl apply the brake until bowl
680 and wipe dry with a lint free cloth.
has stopped.
(b) Inspect all parts thoroughly. Replace ball
(b) Remove two cover clamps; remove cover
check valves that do not seat properly and springs that have
and lock bowl in frame with bowl locking screw on each side of
lost tension.
purifier frame.
(5) Assembly. Assembly is in reverse order of
(c) Remove the coupling ring (5, fig. 5-91)
disassembly.
and lift bowl top (17) from bowl by lifting at top disc (2).
1. Tubular shaft
2. Top disc
10.
Spindle
3.Coupling nut
11.
Locating pin
4. Discharge gasket
12.
Driving bushing
5. Coupling ring
13.
Locating lug
6. Bowl ring gasket
14.
Intermediate top disc
7. Intermediate discs
15.
Driving bushing pin
8. Bottom disc
16.
Discharge ring
9. Bowl shell
17.
Bowl top
Figure 5-91. Sectional view of bowl.
5-121
|
||
|
||
