| Tweet |
Custom Search
|
|
|
||
 TM 55-1925-273-10-1
0092 00
WARNING
Work should never be held by hand. The force of the drill bit could "throw" work and
seriously injure or kill the operator.
! CAUTION
Always place a piece of scrap material below work to protect the table from damage.
c.
Secure the work to the table by blocking and clamping securely to the table.
d.
To adjust the table height:
(1)
Loosen the column lock handle.
(2)
Turn the table crank handle (figure 4, item 4) to the desired height.
(3)
Tighten the column lock handle.
e.
To operate the drill press:
(1)
Set the M (motor) power switch (figure 4, item 5) to ON.
(2)
Set the L (light) switch (figure 4, item 5) to ON.
(3)
Turn the handle (figure 4, item 6) to lower the bit and drill the hole.
3.
To secure the drill press:
a.
Raise the spindle to the UP position by turning the handle (figure 4, item 6).
b.
Turn off the drill press by setting the M and L power switches (figure 4, item 5) to OFF.
0092 00-6
|
||
|
||
