| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-15
CHAPTER 4
INTERMEDIATE GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
Page
Repair Parts, Special Tools; Test, Measurement, and
Diagnostic Equipment (TMDE); and Support Equipment ............................................................. 4-1
Service Upon Receipt ................................................................................................................ 4-1
Intermediate General Support Preventive Maintenance
Checks and Services (PMCS) ..................................................................................................... 4-2
Intermediate General Support Troubleshooting ........................................................................... 4-2
Intermediate General Support Maintenance Procedures ............................................................. 4-5
Preparation for Storage or Shipment ........................................................................................... 4-50
Section I. REPAIR PARTS, SPECIAL TOOLS; TEST,
MEASUREMENT, AND DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT
4-1. Common Tools and Equipment . For authorized common tools and equipment, refer to the Modified Table of
Organization and Equipment (MTOE) applicable to your organization.
4-2. Special Tools, TMDE, and Support Equipment . Special tools; test, measurement, and diagnostic equipment;
and support equipment requirements are listed and illustrated in the Repair Parts and Special Tools List (RPSTL), TM
55-1905-223-24P. These items are also listed in the Maintenance Allocation Chart (MAC), Appendix B of this manual.
4-3. Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools List (RPSTL), TM 55-
1905-223-24P.
Section II. SERVICE UPON RECEIPT
4-4. Checking Unpacked Equipment.
a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report the
damage in accordance with the instructions of DA Pam 738-750.
b. Check the equipment against the packing slip to see if the shipment is complete. Report all discrepancies in
accordance with the instructions of DA Pam 738-750.
c. Check to see whether the equipment has been modified.
d. Remove protective caps, plugs, inserts, wrappings, and tape when inspection/ inventory is completed. Inspect
piping openings for damage. Wipe off dirt, grease, or protective films at time of installation.
4-1
|
||
|
||
