ADJUST CONTROL LINKAGES AT TRANSMISSION AND INJECTOR PUMP

Custom Search

CONTROL CABLE AND LINKAGE ADJUSTMENT INSTRUCTIONS (TRANSMISSION AND ENGINE)

TM-5-1940-277-20 Boat Bridge Erection Twin Jet Aluminum Hull MODEL USCSBMK1 (1940-01-105-5728) MODEL USCSBMK2 (1940-01-218-9165) Manual

TRANSMISSION CABLE REPLACEMENT INSTRUCTIONS

TM 5-1940-277-20

TM 1940-20/2

ADJUST CONTROL LINKAGES AT TRANSMISSION AND INJECTOR PUMP:

Open and secure engine hatches (refer to paragraph 3-154).

MK1 AND MK2 W/SABRE

MK2 W/CUMMINS

Using 7/16 inch wrench loosen nut (3).

Using pliers remove cotter pin (4) or e-clip (9) from cable pivot (5) at transmission (6) or injector

pump (7).

Remove cable pivot from injector pump or transmission control lever (8).

Place transmission selector handle and transmission control lever in neutral position.

Place throttle control lever full forward

Rotate cable pivot (5) to adjust cable length.

Reinstall cable pivot (5) on injector pump control lever (7) or transmission control lever.

Using pliers install new cotter pin (4).

10.

Flare end of cotter pin (4).

11.

Using 7/16 inch wrench tighten nut (3).

12.

Close engine hatches.