FENDERING (RUBBER RUB RAIL) REPLACEMENT INSTRUCTIONS

Custom Search

INSTALL

TM-5-1940-277-20 Boat Bridge Erection Twin Jet Aluminum Hull MODEL USCSBMK1 (1940-01-105-5728) MODEL USCSBMK2 (1940-01-218-9165) Manual

REMOVE

TM5-1940-277-20

TM 1940-20/2

3-151. FENDERING (RUBBER RUB RAIL) REPLACEMENT INSTRUCTIONS

TOOLS: Ratchet 3/8 in. Drive

13 mm Socket w/(3/8 in. Drive)

6 inch Extension

Electric Drill

1/2 inch Drill

1-1/4 inch Hole Cutter

13 mm Box End Wrench

PARTS/MATERIALS: Fendering (Rub Rail) Replacement Section

PERSONNEL REQUIRED: Two

NOTE

The fendering (rubber rub rail) is fitted in three sections from stern to bow on each side

(port or starboard). These fendering (rubber rub rail) sections are held in place by metal

inserts extending from bow to stern. The stern section (A) must be removed to replace

the center section (B). Both the stern section (A) and center section (B) must be removed

to replace the bow section (C). Ensure that 1-3/4 inch bolt is installed through metal in-

sert at second from last hole on Section A.

3-318