| Tweet |
Custom Search
|
|
|
||
 TM 5-2805-261-13
LOCATION/ITEM
ACTION
REMARKS
4-17. FLYWHEEL REMOVAL/INSTALLATION - continued
5. Flywheel (4)
Remove.
NOTE
Use a universal puller to re-
move flywheel. Install cap-
screws in holes for capscrews
(2). Apply tension and pop
flywheel loose by hitting
center of pressing screw with
a brass hammer.
WARNING
Drycleaning solvent, P-D-680,
used to clean parts is poten-
tially dangerous to personnel
and property. Avoid repeated
and prolonged skin contact
by wearing rubber or non-
porous gloves when handling
the solvent or material wet
with drycleaning solvent.
Wash hands immediately
after exposure with soap and
water and use a lanolin based
skin cream to prevent skin
drying. Do not use near open
flame or excessive heat. Flash
point of solvent is 100
F
(38 ). Do not work with
C
solvent in a closed room. Be
sure there is good ventilation
or the solvent vapors will
build up in the air and become
a poisonous mixture which
can cause physical injury or
even death.
1. Crankshaft and flywheel
Clean tapers.
2. Ratchet (3)
Install on flywheel with
capscrews (2).
3. Flywheel (4)
Place in position on crank-
shaft.
4. Flywheel nut (1)
Install and tighten to torque
Use strap wrench to hold flywheel in place.
of 100-105 lb ft (135-140
N.m).
Do not let solvent wash oil out of breaker point oiler
wick.
CAUTION
A loose flywheel nut will cause damage to
the crankshaft.
Change 1
4-23
|
||
|
||
