| Tweet |
Custom Search
|
|
|
||
 TM 5-2805-261-13
LOCATION/ITEM
ACTION
REMARKS
5-6. CARBURETOR DISASSEMBLY/ASSEMBLY - continued
10. Float hinge pin (16)
Remove.
11. Float (17)
Remove.
CLEANING
WARNING
Drycleaning solvent, P-D-680,
used to clean parts is poten-
tially dangerous to personnel
and property. Avoid repeated
and prolonged skin contact
by wearing rubber or non-
porous gloves when handling
the solvent or material wet
with drycleaning solvent.
Wash hands immediately
after exposure with soap
and water and use a lanolin
based skin cream to prevent
skin drying. Do not use near
open flame or excessive heat.
Flash point of solvent is
100 (38 ). Do not work
F
C
with solvent in a closed
room. Be sure there is good
ventilation or the solvent
vapors will build up in the
air and become a poisonous
mixture which can cause
physical injury or even death.
1.
Jets and passages
a. Clean with solvent.
Be sure to remove all gum and varnish.
b. Dry with clean lint-free
cloth.
2.
Needle valves
a. Clean with solvent.
b. Dry with clean lint-free
cloth.
ASSEMBLY
1.
Float (17)
Position hinge and insert
Be sure hinge moves freely, with no binding.
float hinge pin (23).
2.
Float chamber assembly
Position on carburetor.
(12) and gasket (13)
3. Capscrew (11 )
Install.
4. Throttle return spring (9)
Install.
and retainer (10)
5. Roll pin (8)
Install.
6. Choke arm and screw
Remove.
assembly (15)
7. Lead shot (7)
Install.
See para. 4-27.
8. Core plugs (5) and (6)
Install.
See para. 4-27.
9. Needle valve assembly
Install.
See para. 4-27.
(4)
10. Needle valve (2) and
Install.
See para. 4-27.
retainer (3)
11. Carburetor (1)
Install.
See para. 4-28.
5-12
|
||
|
||
