HYDROSTARTER - TM-55-1905-219-14-10371

Custom Search

HYDROSTARTER FILTER

TM-55-1905-219-14-1 Landng Craft Utility LCU 1667 - 1670 (1905-00-168-5764) Manual

HYDRAULIC TANK DRAIN

TM 55-1905-219-14-1

Table 2-1. PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) - continued

Location

Item

Item to Check/

Not Mission

No.

Interval

Service

Procedure

Capable :

181

ANNUAL

Anchor Winch

HYDROSTARTER. Remove the

Compartment

hydrostarter from the engine for lubrication.

Before removing the hydrostarter, release

the pressure in the system by means of the

relief valve (40) on the hand pump (41).

Then remove three bolts (42) and washers

(43) that attach starting motor (44) to the

flywheel housing. Remove the starting motor

without disconnecting the hydraulic hoses.

Apply a grease (MIL-L-24139A (SH)) on

drive clutch pinion (45) so that it will slice

freely while compressing spring. Also apply

grease to the fingers of clutch fork (46) and

spool of clutch yoke (47).

Remove pipe plug (48) from starting motor

drive housing (44) and saturate shaft oil wick

(49) with engine oil. Re-install the plug (48).

After lubricating, install starting motor on the

flywheel housing and recharge the

accumulator with the hand pump.

Change 4 2-223