| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-2
2-100.
OIL/WATER SEPARATION SYSTEM (Cont).
c.
The oil/water separator is also used to pump used engine oi1 into the holding tank, or a separate container.
d. The following is an index of the operating procedures:
DESCRIPTION
PARAGRAPH
Pre-start Adjustments
Bilge Draining
Used Engine Oils
Emptying Holding Tank
2-101.
PRESTART ADJUSTMENTS.
The following adjustments should be performed prior to starting the system. Refer to FO-54 for component locations.
(a)
Aft Engine Room.
(1)
Close sample/drain valve (1) at base of pre-filter separator .
(2)
Close sample/drain valve (2) at base of 2nd stage separator.
(3)
Close sample/drain valve (3) at base of 3rd stage separator.
(4)
Close manual oil discharge valve (4).
(5)
Close manual bypass shutoff valve (5).
(6)
Open manual shutoff valve (6).
(7)
Open intervessel shutoff valve (7).
(8)
Open intervessel shutoff valve (8).
NOTE
The following steps (9 thru 15) need be performed
only when the equipment is to be operated for the
first time.
When removing covers be careful not to damage the
float of the air eliminator valve (9) on the bottom,
of the cover.
(9)
Lift cam bar (10) and remove cover (11).
(10) Lift cam bar (12) and remove cover (13).
2-559
|
||
|
||
