| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-2
5-12.2.
STARTING MOTORS (ELECTRIC) (Continued).
LOCATION/ITEM
ACTION
REMARKS
ASSEMBLY (Cont)
14. Middle
a.
Install sleeve bearing (29)
Use arbor press.
Bearing
in bearing bracket (30) if
Assembly
removed, as follows:
If bearing is worn more than
0.005 inch (0.013 cm) beyond
maximum dimension, as listed
below, they should be replaced.
Wear will be greatest on side
which sustains the greatest
thrust during cranking. After
a new bearing is pressed into
place, cross-drill oil hole.
Ream to finish size as listed
below, and remove burrs in oil
passage. Finish size of
bearing is:
Middle bearing,
ID........ 0.997...... 0.999 inch
(2.532..... 2.537 cm)
b.
Press new seal (28) into
bearing bracket.
c.
Install oil hole plug (27).
d.
Apply 8 to 10 drops of engine
If removed.
oil OE-10 (MIL-L-2104) to
lubricating wick (26) and
install wick (26), and pipe
plug (25).
5-194
|
||
|
||
