| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-2
5-12.2.
STARTING MOTORS (ELECTRIC) (Continued).
LOCATION/ITEM
ACTION
REMARKS
ASSEMBLY (Cont)
15. Drive
Install sleeve bearing (18) in
If removed.
Housing
drive housing (19) as follows:
Use arbor press.
a.
If bearing is worn more than
0.005 inch (0.013 cm) beyond
maximum dimension, as listed
below, they should be replaced
Wear will be greatest on side
which sustains greatest thrust
during cranking. After a new
bearing is pressed into place,
cross-drill oil hole. Ream to
finish size as listed below, and
remove burrs in oil passage.
Finish size of bearing is:
Drive end housing
bearing,
ID........ 0.8145....... 0.8165 inch
(2.0688...... 2.0739 cm)
b.
Place lubricating wick
(17) in housing.
c.
Apply 8 to 10 drops of
If removed.
engine oil OE-10 in reservoir
and secure passage
with pipe plug (16).
5-195
|
||
|
||
