| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-2
5-14. ROCKER ARMS, CAM FOLLOWERS AND PUSHRODS (Continued).
LOCATION/ITEM
ACTION
REMARKS
ASSEMBLY (Cont)
(3) Install roller (17) in
position in cam roller
body. The plunger, when
released, will extend
into the roller bushing
and assure accurate
alignment of the bushing
with the roller pin holes
in the follower body.
(4) Start the roller pin (16)
squarely into the follower.
Then, carefully drive the
pin into the assembly (15)
until the pin is centered
in the legs of the follower.
(5) Check the side clearance
between the roller and
the follower body. This
clearance must be .015
inch (0.038 cm) to
.023 inch (0.058 cm).
NOTE
Immerse a new or solvent-cleaned cam follower
assembly in clean engine oil for at least five
minutes before placing it in the cylinder head.
This will ensure initial lubrication over the
full length of the cam follower roller pin, and
is essential to satisfactory cam follower perfor-
mance. Rotating the cam roller during this
period will aid in introduction of oil to the cam
roller pin.
5-290
|
||
|
||
