| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-38. TRANSFER GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
c. Support the transfer gear housing
(8) on wood blocks with the for-
ward face of gear housing down,
and high enough so the driven
shaft will clear the floor when
installed in the gear housing.
d. Lubricate the balls and the
outside diameter of the bearing
(14) with engine oil. Then,
insert the forward end of the
driven shaft (3) straight through
the bearing bore of the gear
housing and start the bearing
straight into the bearing bore.
e. Tap against end of driven shaft
(3) with a plastic hammer and
drive the bearing and shaft
assembly down until the bearing
seats in gear housing.
f. Install driven shaft bearing
retainer (16) on transfer gear
housing as follows:
1.
Affix a new gasket (42) to the
forward face of the bearing
retainer.
6-811
|
||
|
||
