| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-38. TRANSFER GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
NOTE
Since the bolt holes in the gasket and bearing retainer are not equally spaced, they can only be
attached to the gear housing in one position .
2.
Screw 7/16"-14 X 3" pilot
studs in two diametrically
opposite bolt holes.
3.
Lubricate the lip of oil seal
(15) in the bearing retainer
with engine oil. Then, rotate
the bearing retainer so the
bolt holes in the retainer
will be in alignment with the
bolt holes in the gear housing.
4.
Place the bearing retainer
(16) straight and true over
the end of the driven shaft
and over the pilot studs,
being very careful not to
damage lip of the oil seal.
Push the retainer down against
the gear housing.
5.
Install six 7/16"-14 X 1-5/8"
bolts (40) with lockwashers
(41) then remove the pilot
studs and install the two
remaining bolts (40) and
lockwashers (41). Tighten
bolts to 46-50 ft-lb (62.4-
67.8 Nm) torque.
6.
Rotate the driven shaft (3)
and check for freeness.
NOTE
Use one or more bearing retainer gaskets to obtain the minimum end play but maintain oil seal.
6-812
|
||
|
||
