| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-39. REVERSE GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
24. Reverse Gear
NOTE
If the reverse clutch drive pins (14) were removed from the reverse gear housing (19) proceed as
follows. If the pins were not removed proceed to step e.
a. Support the reverse gear
housing (19) on wood blocks,
with the rear face of the
housing down.
b. Note the scribe marks placed
on the gear housing (19) at
the time the old pins were
removed. Start a new drive
pin (14) in each of the drive
pin holes in the forward face
of the gear housing, with the
square head of the drive pin
in line with the scribe
mark.
c. With a soft (lead) hammer,
drive the pins (14) straight
into the gear housing (19)
until the head of the pins
contact the surface of the
gear housing.
6-882
|
||
|
||
