| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-39. REVERSE GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
NOTE
The sides of the pins must align with the scribe marks in the gear housing (19). If a pin has
twisted slightly out of line when installing, line it up with a wrench.
d. Place the reverse clutch
piston (12) - without the
seal ring - down over the
drive pins (14) to assure the
heads of the pins will engage
the slots in the piston
without binding. Then,
remove the piston from the
reverse gear housing.
NOTE
If the oil transfer sleeve (43) in the reverse gear housing (19) requires replacement proceed. If the
sleeve was not removed, proceed to step i.
e. Support the reverse gear
housing (19) on the bed of a
hydraulic press with the
forward face of the housing
up.
6-883
|
||
|
||
