| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-39. REVERSE GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
j. Place the bronze thrust
washer (40) over the aft end
of the reverse gear drive
shaft (6). Place the steel
thrust washer (41) over the
aft end of the shaft with the
wide flat face of the washer
next to the bronze thrust
washer. Install the snapring
(42) in the groove in the
shaft, then slide the steel
thrust washer back over the
snapring.
k. Apply a small amount of cup
grease in each of the oil
seal ring grooves in the
reverse gear drive shaft (6).
Then, slip the oil seal rings
(39) in turn, over the end of
the shaft and into the
grooves in the shaft. Hook
the ends of the oil seal
rings together.
CAUTION
Do not spread the seal rings more than necessary to slip them over the shaft, to avoid breakage.
6-885
|
||
|
||
