REMOVAL - TM-55-1905-222-140267

Custom Search

REPLACE THROTTLE LINKAGE

TM-55-1905-222-14 Landing Craft Mechanized (LCM-8) (ROHR and Gunderson Models) (1905-01-284-2647 AND 1905-01-284-2648) Manual

INSTALLATION

TM 55-1905-222-14

5-8 REPLACE THROTTLE LINKAGE (Continued).

DISCONNECT

THROTTLE

CABLE

AND

ARTICULATOR FROM THE RED KNOB CONTROL

UNIT IN ENGINE ROOM.

Remove nut (9) and washer (10), remove cable

connector (11).

Loosen locknut (12) and remove cable connector

(11) from articulator (13).

Remove screw (14) from control unit (15).

Loosen locknuts (16 and 17), remove cable

adapter bushing (18) from articulator (13) and

throttle cable (19).

Observe cable route from pilothouse to engine

room. Pull throttle cable (19) down.

DISCONNECT GOVERNOR CONTROL

ROD

ASSEMBLY FROM CONTROL UNIT.

Measure and record the length "A" from center to

center of rod ends (22) before removing.

Remove hex nuts (20) and lock-washers (21);

remove rod ends (22) from coupling tube (23).

NOTE

Hex nuts (25) may be loosened to disconnect rod end (22) from connecting

rod (24). Do not disconnect unless adjustment is necessary.

5-19