DISASSEMBLY - TM-55-1905-222-140420

Custom Search

REPAIR RAMP WINCH

TM-55-1905-222-14 Landing Craft Mechanized (LCM-8) (ROHR and Gunderson Models) (1905-01-284-2647 AND 1905-01-284-2648) Manual

DISASSEMBLY-cont.

TM 55-1905-222-14

6-10

REPAIR RAMP WINCH (Continued).

c. Remove and discard 'O' ring (7)

from end cover (6).

d. Remove thrust plate (8) from the

final planet assembly (9).

NOTE

Care must be taken not to damage the pilot bore in final drive housing that carries the end

cover.

e. Using two pinch bars under rim of planet hub

and against end of final drive housing (3),

pull planet assembly (9) off splined end of

drum.

Remove sun gear shaft (10),. Then remove

snap ring (11) and 'O' ring (12). Discard 'O' ring.

NOTE

Do not remove taper seal ring (13) unless tapered diameter has roughness or scratches.

g. Remove taper seal ring (13) using a

punch between the gear teeth to

drive the ring off the shaft.

6-40