| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-10
NOTE
If clutch does not engage, jog drive gently by shifting HAUL BACK-PAY OUT switch (3,
engage, taking strain off anchor holdback wire rope.
(d) Lock CLUTCH LEVER (4, FIGURE 2-184).
(e) Disconnect ANCHOR HOLDBACK TURNBUCKLE (1, FIGURE 2-185).
(f) Slowly turn BRAKE HANDWHEEL (2, FIGURE 2-184) counterclockwise to release brake.
(g) Slowly turn HAUL BACK-PAY OUT SWITCH (3, FIGURE 2-183) to HAUL BACK position until dog
lug is free in MAIN SPOOL (1, FIGURE 2-184).
(h) Push DOG LEVER (3) aft until dog is away from MAIN SPOOL (1).
(i) Turn BRAKE HANDWHEEL (2) clockwise, to tighten brake.
(2) Release CLUTCH LEVER (4).
NOTE
If clutch does not release, jog drive gently by shifting HAUL BACK- PAY OUT
switch to PAY OUT, and quickly releasing it. This allows the clutch to release.
With stern anchor winch in standby condition, anchor is secured only by brake and
can be quickly released by turning brake handwheel counterclockwise to lower the
anchor.
CAUTION
Do not pay out the last row of the cable on the drum. Loss of anchor or improper
rewinding of cable may occur. The operator may paint the last row of the cable left
on the drum, "yellow' for a quick reminder during operation.
(3) Turn BRAKE HANDWHEEL (2) counterclockwise slowly to pay out anchor at a slow speed. Turn
BRAKE HANDWHEEL (2) clockwise to stop anchor descent at desired length.
(4) Engage dog lug on MAIN SPOOL (1) as follows:
(a) Engage CLUTCH LEVER (4).
(b) Turn HAUL BACK-PAY OUT switch (3, FIGURE 2-183) to allow MAIN SPOOL (1, FIGURE 2-184) to
creep until dog lug will enter the spool flange.
(c) Pull DOG LEVER (3) forward, setting dog.
Change 2
2-518
|
||
|
||
