| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-10
(9) Release CLUTCH LEVER (4, FIGURE 2-184).
NOTE
If clutch does not release, jog drive gently by shifting HAUL BACK-PAY OUT
switch to pay out, and quickly release it. This allows the clutch to release.
e. Warping Head Operation.
WARNING
Before operating stern anchor winch, ensure personnel and foreign objects are
clear of wire rope drum, wire rope, and related components. Moving winch, wire
rope and warping heads can cause serious injury or death.
Keep all personnel clear of winch and wire rope while in operation.
Keep all personnel clear of moving and rotating parts of winch.
Do not attempt to perform any maintenance or repairs while winch is running.
Do not operate this winch with guards removed.
Do not operate hydraulic motor with brake engaged.
(1) On Stern Anchor Winch (FIGURE 2-184) ensure BRAKE HANDWHEEL (2) is fully clockwise, brake
is set. Ensure CLUTCH LEVER (4) is released, and dog is engaged.
(2) On Stern Control Box (FIGURE 2-183), turn HAUL BACK-PAY OUT switch (3) counterclockwise to
haul back position.
NOTE
Releasing tension on standing end of line will allow warping head to lose tension
on line and allow warping head to spin inside the wrapped line.
(3) Release HAUL BACK-PAY OUT switch (3, FIGURE 2-183), stopping the warping head pull on the
line.
f.
Shutdown.
(1) On Stern Control Box (FIGURE 2-183) press STOP pushbutton (4).
(2) On Stern Anchor Winch Motor Controller (FIGURE 2-182) (located in passageway) set ON-OFF
switch (1) to OFF position.
(3) On Main Switchboard (FIGURE 2-181), set STERN ANCHOR WINCH circuit breaker (1) to OFF
position.
|
||
|
||
