| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-10
CAUTION
Stop winch before load reaches crane boom.
Ensure load comes to complete stop and is stable before changing direction of
travel of crane boom.
NOTE
Rescue/Work Boat Crane will be stowed attached to Rescue/Work Boat sling.
Three crew members will be required to launch Rescue/Work Boat.
(1)
Direct three crew member to Rescue/Work Boat station, one to operate REMOTE CONTROL (6)
unit, one to operate HAND CRANK (8), and one to handle Rescue/Work boat.
(2) Remove tie down straps holding Rescue/Work Boat to deck cradle.
(3) Remove REMOTE CONTROL unit (6) from CRADLE (2).
(4) Press UP pushbutton (3) to raise Rescue/Work Boat from its deck cradle to clear hand rail.
(5) Turn HAND CRANK (8) clockwise to position boom outboard ship port side.
(6) Press DOWN pushbutton (4) until Rescue/Work Boat is afloat.
d. Shutdown Procedure.
NOTE
Rescue/Work Boat will be stowed attached to the Rescue/Work Boat sling.
(1) On MOTOR CONTROLLER (7, FIGURE 2-221) set OFF-ON lever to OFF position.
(2) Remove POWER CORD (1) from socket of MOTOR CONTROLLER (7).
(3) Turn WATERTIGHT CAP (5) clockwise on socket of MOTOR CONTROLLER (7).
(4) Replace REMOTE CONTROL unit (6) in CRADLE (2).
2-34. Shore Connections.
a. Power Cable Connection.
WARNING
Ensure that power cable does not enter water. Electrocution, serious injury, or
equipment damage can occur during connection if cable connector gets wet.
2-579
|
||
|
||
