| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-10
CHAPTER 3
INTERMEDIATE DIRECT SUPPORT MAINTENANCE INSTRUCTIONS
Page
Section
I
Repair Parts, Special Tools; Test, Measurement and
Diagnostic Equipment (TMDE); and Support Equipment ................................ ........... 3-1
Section
II
Service Upon Receipt ................................ ............................... ...............................3-1
Section
III
Intermediate Direct Support Preventive Maintenance Checks
and Services (PMCS) ................................ ............................... ...............................3-2
Section
IV
Intermediate Direct Support Troubleshooting ................................ ............................3-2
Section
V
Intermediate Direct Support Maintenance Procedures ................................ ............... 3-3
Section
VI
Preparation for Storage or Shipment ................................ ............................... ......... 3-6
Section I. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC
EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT
3-1. Common Tools and Equipment . For authorized common tools and equipment refer to the Modified Table of
Organization and Equipment (MTOE) applicable to your organization.
3-2. Special Tools, TMDE, and Support Equipment . Special tools; test, measurement, and diagnostic equipment;
and support equipment requirements are listed and illustrated in the Repair Parts and Special Tools List (RPSTL), TM
55-1905-223-24P. These items are also listed in the Maintenance Allocation Chart (MAC), Appendix B of this manual.
3-3. Repair Parts . Repair parts are listed and illustrated in the Repair Parts and Special Tools List (RPSTL), TM 55-
1905-223-24P.
Section II. SERVICE UPON RECEIPT
3-4. Checking Unpacked Equipment .
a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report the
damage in accordance with the instructions of DA Pam 738-750.
b. Check the equipment against the packing slip to see if the equipment is complete. Report all discrepancies in
accordance with the instructions of DA Pam 738-750.
c. Check to see whether the equipment has been modified.
3-1
|
||
|
||
