| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-12
CHAPTER 4
INTERMEDIATE GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
Page
Section I
Repair Parts, Special Tools; Test, Measurement and
Diagnostic Equipment (TMDE); and Support Equipment .................................................................. 4-1
Section II
Service Upon Receipt ...................................................................................................................... 4-1
Section III
Intermediate General Support Preventive Maintenance
Checks and Services (PMCS).......................................................................................................... 4-2
Section IV
Intermediate General Support Troubleshooting................................................................................ 4-3
Section V
Intermediate General Support Maintenance Procedures .................................................................. 4-5
Section VI
Preparation for Storage or Shipment................................................................................................ 4-24
Section I. REPAIR PARTS, SPECIAL TOOLS; TEST,
MEASUREMENT, AUD DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT
4-1. Common Tools and Equipment. For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to
your organization.
4-2. Special Tools, TMDE, and Support Equipment. Special tools; test,
measurement, and diagnostic equipment; and support equipment requirements are
listed and illustrated in the Repair Parts and Special Tools List (RPSTL),
TM 55-1905-223-24P. These items are also listed in the Maintenance Allocation
Chart (MAC), Appendix B of this manual.
4-3. Repair Parts. Repair parts are listed and illustrated in the Repair Parts
and Special Tools List (RPSTL), TM 55-1905-223-24P.
Section II. SERVICE UPON RECEIPT
4-4. Checking Unpacked Equipment.
a. Inspect the equipment for damage incurred during shipment. If the
equipment has been damaged, report the damage in accordance with the
instructions of DA Pam 738-750.
b. Check the equipment against the packing slip to see if the shipment is
complete. Report all discrepancies in accordance with the instructions of
DA Pam 738-750.
c.
Check to see whether the equipment has been modified.
4-1
|
||
|
||
