| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-16
b.Fairlead With Roller Swivel. (FIGURE 4-1)
(1)
Attach lifting device and sling to fairlead with roller swivel (21).
(2)
Lift fairlead with roller swivel into position over mounting pad and align with boltholes.
(3)
Install ten machine bolts (1) and self-locking hexagon nuts (2) and secure fairlead with roller swivel to
mounting pad (22).
(4)
Remove lifting device and sling.
(5)
Grease fairlead with roller swivel (LO 55-1905-223-12).
c. Single Leg Wire Rope Assembly. (FIGURE 4-2)
(1)
Use lifting device and sling to position full reel containing new single end wire rope assembly on stand at
dockside.
(2)
Pull sufficient amount of wire rope off reel.
(3)
Direct end of wire rope through levelwind carriage (3).
(4)
Attach end of wire rope to spool with clamp provided in flange.
NOTE
Transfer of wire rope assembly is from top of reel to top of empty spool.
(5)
On bulkhead directly behind winch assembly, push START button on stern control box.
(6)
At winch assembly, ensure that locking device is released from spool flange when dog lever (7) and clutch
lever (6) is engaged.
(7)
Slowly unscrew brake wheel (5) counterclockwise.
(8)
On stern control box, move control switch to HAULBACK mode to transfer wire rope assembly from reel to
empty spool.
(9)
Maintain tension on wire rope at reel.
(10) On stern control box, move control switch to neutral when wire rope transfer completed at levelwind carriage
(3).
(11) Use lifting device and sling to remove empty reel and stand to a secure area.
(12) On stern control box, move control switch to PAYOUT mode. Direct end of wire rope assembly (1) through
fairlead with roller swivel (2).
4-13
|
||
|
||
