| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-18-1
j. Remove machine screw (29, Sheet 2), terminal board (30) and terminal board
cover (28).
k.
Remove hexagon head capscrew (26, 27) and remove ground wires (21, 25).
l.
Remove plain hexagon nuts (32), cupped washer (23), plain hexagon nut (31).
and flat washer (24).
a.
Install flat washer (24), plain hexagon nut (31), cupped washer (23), and
plain hexagon nut (32).
b.
Install ground wires (21, 25) and hexagon head capscrews (26, 27).
c.
Install terminal board cover (28), terminal board (30), and machine screw
(29).
d.
Install bracket (5) and hexagon head capscrew (22).
e.
Install dryer bulkhead (9).
f.
Install cupper washer (8) and hexagon head capscrews (6, 7).
NOTE
The heater box must be installed on the dryer rear
bulkhead prior to installation in cabinet, refer
Install dryer rear bulkhead (3) and machine screws (4, 10).
g.
h.
Install roller (13), flat washer (12) and bolt (11).
i.
Install bolt (14) and locknut (20).
Install thrust washer (15), roller (16), flat washer (18), and retaining ring
j.
(17).
k.
I n s t a l l seal (1).
l.
Install retaining strap (2) and spring (19).
m.
Refer to paragraphs 2-89, 2-90, and 2-92.
|
||
|
||
