REPAIR - TM-55-1905-223-24-18-20222

Custom Search

DISASSEMBLY-CONT

TM-55-1905-223-24-18-2 Landing Craft Utility (LCU) NSN 1905-01-154-1191 Basic Craft Part II Manual

ASSEMBLY

TM 55-1905-223-24-18-2

(3) Tag and, using a soldering iron, unsolder electrical wires from electrical receptacle.

(4) Remove electrical receptacle (44), gasket (40) and insulting tubing (41).

(5) Remove jumper wire (46) and protective cap (47) from electrical receptacle (44).

r. Electrical receptacle (48).

NOTE

Receptacle plug (2 socket plug) disconnected during removal

procedure.

Repeat steps p.(l) through (4) to remove electrical receptacle (48).

s. Grommet (8).

(1) Pull electrical wiring and cable harnesses clear of grommet (8).

(2) Remove grommet from bracket (9).

REPAIR

Repair of receiver module consists of replacing gaskets (28, 32, 40) 3-places, meter (31), dust and

moisture seal boot (52), wirewound variable resistor (51), power supply (20), power transformer (25),

electrical receptacle connector (39), insulating tubing (41) 3-places, receptacle plug (45, 49).

ASSEMBLY

a. Position receiver module silk screened box (26) on a clean flat surface.

b. Grommet (8).

(1) Install grommet on bracket (9).

(2) Direct electrical wiring and cable harnesses through grommet (8).

c. Electrical receptacle (48).

(1) Position gasket (40) and electrical receptacle (48) over mounting hole with electrical wires exposed.

(2) Install insulating tubing (41) on electrical wires.

(3) Connect by soldering electrical wires to electrical receptacle (48). Remove tags.

(4) Lower electrical receptacle and gasket over mounting screw holes on silk screened box (26).

3-200