| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
(13) Install the pins in the crankshaft oil seal drive (Figure 3-77).
(14) Use the crankshaft oil seal driver to install the oil seal in the rear cover (Figure 3-77).
(15) Install the four capscrews that hold the oil pan to the rear cover. See Figure 3-64.
FIGURE 3-77. Installing Seal With Driver.
(16) Tighten one of the 7/16-inch oil pan mounting capscrews on each side of the oil pan, halfway
between the front and the rear of the oil pan, to 15 ft-lb (20 N m) torque.
(17) Tighten the four 5/16-inch capscrews in the rear of the oil pan to 20 ft-lb (25 Nm) torque in the
sequence shown in (Figure 3-78).
(18) Tighten the thirty-two (32) 7/16-inch capscrews to 50 ft-lb (70 N m) torque in the sequence shown
c. Install the flywheel assembly as follows:
NOTE
The pilot bearing must be installed flush with the pilot bore surface. Refer to
3-125
|
||
|
||
