| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
(5)
Remove gasket (16) and discard.
REPLACEMENT
NOTE
Make sure that the covers and gasket surfaces on the housings and cylinder
block are clean before installing.
Return each rocker lever housing to its original location on the engine.
a.
Install new rocker lever housing gaskets on the cylinder heads (FIGURE 2-31).
b.
Install two guide studs in each cylinder head.
FIGURE 2-31. Rocker Lever Housing Gaskets .
CAUTION
If the adjusting screws protrude beyond the maximum of 1.2540 inches from the
top surface of the lever and the ball end of the adjusting screws, the push rods
can be damaged when the housing capscrews are tightened.
c.
Loosen the rocker lever adjusting screws so there is a maximum of 1.2540 inches (32.0 mm) from the
top surface of the lever and the ball end of the adjusting screw (FIGURE 2-32).
2-111
|
||
|
||
