| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
INSPECTION/REPAIR
a.
Visually inspect the oil pan and nonmetallic hose assembly for cracks or holes.
b.
Remove threaded tapping screws (5) and remove sediment strainer element (6).
c.
Replace sediment strainer element (6), gaskets (1, 12, 19), and nonmetallic hose assembly (14).
d.
Clean parts with solvent (Item 5, Appendix C).
REPLACEMENT
NOTE
Ensure the gasket surfaces are clean before installing oil pan.
a.
Install sediment strainer element (6) with threaded tapping screws (5).
b.
Position the oil pan and new gasket (1). Use your hand to install the captive washer capscrews (23,
24).
c.
Use the following sequence to tighten the capscrews. This will prevent damage to the oil pan or
flywheel housing.
(1)
Install and tighten the middle capscrew in each of the two buttresses on the flywheel
housing (FIGURE 2-60).
FIGURE 2-60. Flywheel Housing Buttresses.
2-163
|
||
|
||
