| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-5
(a) Lubricate new liner preformed packings (2, FIGURE 4-55) and gasket (3)
with vegetable oil.
(b) Install the preformed packings (2) and the gasket (3) as follows:
1 Install the gasket (3, FIGURE 4-55) in the top groove of the liner (4).
2 Install the preformed packings (2, FIGURE 4-55) in the center and the bottom grooves.
CAUTION
Do not use excessive amount of sealant.
Excessive sealant can
cause problems in the cooling system.
(c) Apply a bead of RTV type sealant on either the cylinder block counterbore or the liner flange. The
liner must be installed within 5 minutes after the sealant is applied (FIGURE 4-59) .
NOTE
The diameter of the bead must be at least 3/64-inch and not more than 1/16-inch.
(d) Lubricate the gasket and the preformed packing with vegetable oil. Install the liner in the bore with a
quick push.
FIGURE 4-59.
Applying Sealant to Liner.
4-104
|
||
|
||
