| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0058 00
PROPULSION ENGINE FUEL FILTER/WATER SEPARATOR REPLACEMENT
REMOVAL
1.
CLOSE the fuel supply valve upstream of the fuel filter/water separator.
2.
Don chemical protective gloves and goggles.
3.
Position a suitable drain pan beneath the fuel filter/water separator.
4.
Label the inlet and outlet hoses (12 and 13) to permit proper installation. Remove the hoses from the inlet and outlet
elbows (14 and 15).
5.
Remove the indicator line (16) from the outlet elbow (15).
NOTE
Cotter pins, lockwashers, locking nuts, and similar locking devices shall be discarded after removal and replaced with
new cotter pins, lockwashers, locking nuts and similar locking devices.
6.
Remove the four capscrews (17) and self-locking nuts (18) from the bracket clamps (19) and remove the fuel filter/water
separator (20). Discard the self-locking nuts.
7.
Remove the inlet and outlet elbows (14 and 15) and bushings (21) from the fuel filter/water separator (20).
23
22
12
20
18
16
14
19
21
15
17
21
13
INSTALLATION
1.
Wrap the bushing's (21) threads with antiseizing sealant tape and install the bushings and inlet and outlet elbows
(14 and 15) in the inlet and outlet ports of the new fuel filter/water separator (20).
2.
Align the mounting holes and secure the bracket clamps (19) with the four capscrews (17) and new self-locking nuts (18).
3.
Connect the inlet and outlet hoses (12 and 13) to the inlet and outlet elbows (14 and 15) using the labels from step 4 of
Removal--Propulsion Engine Fuel Filter/Water Separator Replacement as a guide.
4.
Connect the indicator line (16) to the outlet elbow (15).
5.
Remove the T-handle (22) and remove the cover (23).
6.
Fill the fuel filter/water separator (20) with clean diesel fuel to prime it.
0058 00-3
|
||
|
||
