| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0166 00
INSTALLATION (continued)
13. Connect the control box wiring (32) to the terminal block (31) using the labels from step 17 of Removal as a guide.
14. Position the control box cover (29) on the control box (30) and secure it with the screws (28).
15. Connect the exhaust hose (21) to the engine exhaust elbow (27) and secure it with the hose clamps (26).
16. Position the top sound insulating panels (24 and 25) on the frame and secure them with the screws (23).
18. Position the battery box mounting bracket (19) on the vessel structure and secure it with four screws.
19. Place the battery box (18) and battery (17) into the battery box mounting bracket (19).
NOTE
Always connect the negative battery cable last and disconnect it first.
20. Connect the positive (15) battery cable first, and then the negative (14) cable to the battery with the wing nuts (16).
21. Position the battery box cover (13) onto the battery box (18) and secure it with the battery box retaining strap (12) and
wingnuts (11).
22. Wrap the male pipe threads of the through-hull piping (10) with antiseizing sealant tape and install the exhaust discharge
valve (6) and elbow (9) onto the through-hull piping (10). Ensure that the exhaust discharge valve (6) and piping are
oriented to allow installation of the exhaust hose (5).
24. Slide the exhaust hose (5) over the exhaust discharge valve (6) and secure it with the hose clamps (4).
25. Remove the lockouts and tagouts and check the operation of the diesel generator, ensuring that the engine runs
smoothly, that it runs at the proper speed, that it will produce the proper voltage, and that no leaks are present.
26. When the diesel generator checks out properly, position a new gasket (55) around the BERP opening.
27. Carefully lower the BERP (3) into place on the deck and secure it with the bolts (2) and nuts (1).
END OF WORK PACKAGE
01660166 00-7
00-7/8 blank
|
||
|
||
