| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-242-14
0216 00
DISASSEMBLY--FINAL PLANET ASSEMBLY (continued)
2.
Remove the final planet pin (17) by tapping it out of the planet hub (11) so that it is removed from the splined bore side
of the planet hub.
3.
Remove pin (16) from the final planet pin (17).
4.
Remove the planet gear (18) from the planet hub (11).
5
Drive the ball bearings (19) out of the planet gear (18) using a drift. Remove the snap rings (20) only if the planet gear or
snap rings are to be replaced because of damage.
6.
Repeat steps 1-5 for the remaining planet gears (18).
DISASSEMBLY--PRIMARY DRIVE ASSEMBLY
! CAUTION
Do not remove this assembly as a unit as damage may be caused to the seal diameter of
the primary planet hub and the tapered seal diameter of the taper seal ring on the sun
gear shaft.
1.
Remove the spring cover and motor assembly (refer to WP 0190 00).
2.
If not already removed with the motor, remove the spacer (21), brake hub (22), snap ring (23), and brake ring (24).
3.
Remove the brake plate (25).
4.
Remove the primary planet assembly (26).
5.
Remove the O-ring (27), oil seal (28), seal ring (29), snap ring (30), drain plug (31), and fill plug (32) from the primary drive
housing (33).
32
29
27
23
23
26
30 31
33
22
21
28
24
25
0216 00-4
|
||
|
||
