| Tweet |
Custom Search
|
|
|
||
 1.
Retainer
12.
Body
2.
Plug, vent
13.
Needle
3.
Ball
14.
Sleeve
4.
Body
15.
Gasket
5.
Sleeve
16.
Tip
6.
Filter
17.
Gasket
7.
Gasket
18.
Retainer
8.
Gasket
19.
Push rod
9.
Housing
20.
Seat
10.
Gasket
21.
Spring
11.
Stop
22.
Shim
Figure 3-12. Fuel injector (nozzle), cross section.
(5) Use priming lever (table 4-1) under the
housing cover (15, fig. 3-11). Replace cover on other
shoulder of the pushrod (21, fig. 3-11), and work the
half of housing in a like manner.
shoulder up and down until fuel oil flows out of the vent
(7) Open the starting air valve to the engine.
plug (2, fig. 3-12). When this oil is free of air bubbles,
tighten the vent plug.
(6) Prime each fuel injection pump in turn, as
engine (para. 2-6) and prime that fuel injection pump.
described in steps (3) through (5) above, then replace
3-38
|
||
|
||
