| Tweet |
Custom Search
|
|
|
||
 TM 55-1925-204-12
(2) Remove brakeband from each eyebolt, then lift
(b) Turn the brake handwheel until brake lining is
band away from the drum.
as far away from the drum as it will go.
(3) Position new brakeband around drum, with boss
(c) Tighten the two outer adjusting nuts equally
on the eyebolts, then secure with the two outer adjusting nuts.
toward brake actuating worm, until there is but 1/8 inch air
(4) Adjust new brakeband as described in a.(2)
gap clearance between drum and brake band.
above.
(d) Tighten the two inner adjusting nuts snugly
up to their boss.
c. Bearing and Seal Removal.
(1) Remove motor (para. 5-66).
b. Brake band Replacement.
(2) Drain oil from gear box (fig. 5-104) (LO 55-1925-
(1) Remove the two outer adjusting nuts (fig. 5-103)
204-12-7).
from the eyebolt.
Figure 5-104. Anchor windlass motor and gear box
(3) With coupling removed, remove nuts and
(4) Remove drive end plate and gasket in a similar
washers securing bearing retainer and seal, then remove
manner.
bearing retainer and 3eal.
5-143
|
||
|
||
