| Tweet |
Custom Search
|
|
|
||
 TM 5-2805-261-13
Section III. PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS )
4-7. INTRODUCTION. The preventive maintenance checks and services listed in the PMCS table 4-1 cover procedures to be
performed by organizational maintenance personnel.
4-8. PMCS TABLE. Explanation of the columns:
Item Number. Checks and services are numbered in sequence. This column shall be used as source of item numbers for
the TM Number Column on DA Form 2404, Equipment Inspection and Maintenance Worksheet, in recording results of
PMCS.
Item To Be Inspected. This column gives the name of the item to be inspected or serviced.
Procedures. This column lists inspection procedures.
Equipment Will Be Reported Not Ready/Available If: This column contains the criteria which will cause the equipment to be
classified as not ready or not available because of inability to perform its primary mission.
Table 4-1. Preventive Maintenance Checks and Services
Legend
W - Weekly
M - Monthly
Q - Quarterly
INTERVAL
Equipment Will Be
Item
Item To Be
Reported Not Ready/
No.
W
M
Q
Inspected
Procedures
Available If:
1
Magneto, flywheel assembly
Inspect (para 4-16, 4-17).
Damaged.
2
Ignition coil
Test (para 4-11).
Failed.
3
Test (para 4-11).
Failed.
4
Shorting switch assembly
Inspect (para 4-23).
Failed.
5
Spark plugs
Inspect (para 3-10).
Need replacement.
6
Breaker points
Inspect (para 4-11).
Need replacement.
7
Propeller drive pin
Inspect (para 3-14).
Need replacement.
8
Fuel tank
Inspect (para 4-24).
Leaks or cracks.
9
Carburetor needle valves
Inspect (para 4-27).
Need replacement.
10
Intake manifold
Inspect (para 4-29).
Manifold is damaged or gasket leaks.
11
Cylinder and crankcase
Inspect (para 4-30).
Assembly is damaged.
assembly
12
Cylinder head
Inspect (para 4-30).
Cylinder head is damaged.
13
Steering bracket
Inspect (para 4-32).
Steering bracket is damaged.
14
Water pump
Inspect (para 4-36).
Engine runs hot.
15
Water inlet screen
Inspect (para 4-37).
Screen is damaged.
4-2
|
||
|
||
