STEERING SYSTEM OUT OF ALIGNMENT

Custom Search

ENGINE HAS FUEL KNOCKS

TM-5-1940-277-20 Boat Bridge Erection Twin Jet Aluminum Hull MODEL USCSBMK1 (1940-01-105-5728) MODEL USCSBMK2 (1940-01-218-9165) Manual

ELECTRICAL SYSTEMS INOPERATIVE (Contd).

TM 5-1940-277-20

TM 1940-20/2

Section IV. TROUBLESHOOTING (Continued)

MK1 and MK2 w/SABRE or CUMMINS

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

24. STEERING SYSTEM OUT OF ALIGNMENT.

Step 1.

Check steering cable.

a. Replace steering cable (refer to paragraph 3-42).

Step 2.

Check tie rod.

a. Adjust tie rod (refer to paragraph 3-45).

b. Replace tie rod (refer to paragraph 3-46).

Step 3.

Check hydrojet unit steering assembly (refer to paragraph 3-45).

a. Adjust steering assembly (refer to paragraph 3-45).

Step 4.

Check steering wheel assembly.

a. Repair steering wheel assembly (refer to paragraph 3-43).

b. Replace defective steering wheel assembly (refer to paragraph 3-44).

25. ENGINE RUNS BUT BOAT FAILS TO MOVE.

Step 1.

Check transmissin control setting.

a. Adjust transmission control cables and linkages (refer to paragraph 3-37).

b. Replace defective transmission control cables and linkages (refer to paragraph 3-39).

Step 2.

Check transmission oil level.

a. Fill to proper level.

Step 3.

Inspect drive shaft couplings (refer to paragraph 3-141).

a. Replace defective drive shaft coupling (refer to paragraph 3-141).

26. ELECTRICAL SYSTEMS INOPERATIVE.

Step 1.

Check position of master battery switch.

a. Set master battery switch "ON".

Step 2.

Check battery condition using battery condition meters.

a. If reading below 24 vdc go to Step 4.

BATTERY CONDITION METERS

Change 2

2-31