TM 5-3990-264-13&P
0005
OPERATION - Continued
NOTE
If LHS hook does not disengage, drive vehicle forward approximately two inches (5 cm), and
repeat Steps (18) and (19).
20.
Set transmission range selector (Figure 5, Item 5) to D (drive).
21.
Push in PARKING BRAKE control (Figure 5, Item 3), or release service brake pedal (Figure 5, Item 4).
22.
Drive forward slowly about 5 ft. (1.5 m) to clear LHS hook (Figure 5, Item 22) from IBC bail bar (Figure 5, Item
23). Stop vehicle.
23.
Pull out PARKING BRAKE control (Figure 5, Item 3).
24.
Set transmission range selector (Figure 5, Item 5) to N (neutral).
25.
Set HIGH IDLE switch (Figure 5, Item 13) to ON position.
26.
Move joystick (Figure 5, Item 14) to LOAD position.
WARNING
When NO TRANSIT indicator is illuminated, vehicle may be maneuvered in the immediate
vicinity of the loading/unloading site. However, vehicle is unsafe for road travel. Do not
perform open-road driving when NO TRANSIT indicator is illuminated. Failure to comply may
result in serious injury or death to personnel and damage to equipment.
27.
Release joystick (Figure 5, Item 14) when main frame and hook arm are fully stowed and NO TRANSIT indicator
(Figure 5, Item 24) goes out.
28.
Set HIGH IDLE switch (Figure 5, Item 13) to OFF position.
CAUTION
While maneuvering vehicle in the immediate vicinity of the loading or unloading site, LHS
MODE SELECT switch may be in any setting. However, LHS MODE SELECT switch must
be set to OFF prior to road travel. Failure to comply may result in damage to equipment.
29.
Turn LHS MODE SELECT switch (Figure 5, Item 10) to OFF.
30.
Set PTO ENGAGE switch (Figure 5, Item 11) to OFF position. Indicator light (Figure 5, Item 12) will go out.
END OF TASK
END OF WORK PACKAGE
0005-5/6 blank
03/15/2011Rel(1.8)root(opusualwp)wpno(O04002)
