TM 5-3990-264-13&P
0036
STANCHION PIN ASSEMBLY WIRE ROPE - Continued
Table 1.
Materials List
Name
Part Number (CAGEC)
National Stock Number
Quantity
STRAND, WIRE
M83420/4-010 (81349)
4010-00-575-6233
As Required
SWAGING SLEEVE,
RS290-1 (86831)
4030-00-431-5536
2
WIRE ROPE
1.
Obtain all components required to fabricate stanchion pin assemblies.
2.
Use a fine toothed hacksaw or suitable cutting device, cut strand wire 16 7/8 inches (42.86 cm) long or 12 7/8
inches (32.70 cm) long, depending on which wire is replaced.
3.
Slide strand wire through hole in component, until strand wire comes through other side.
4.
Slide swaging sleeve onto strand wire until swaging sleeve bottoms against component and strand wire comes
through swaging sleeve.
CRADLE ROLLER PIN ASSEMBLY WIRE ROPE
The cradle roller pin assembly is used in 2 places. The strand wire length is the same for each application. Crimped
swaging sleeves are used to attach the strand wire to other components. Each application requires two swaging
sleeves.
CUTTING LENGTH
20 INCHES LONG (53.02 cm)
FINISHED LENGTH
20 INCHES LONG (50.8 cm)
STRAND WIRE
SWAGING
RRW410
1/4 Inch (.63 cm)
SLEEVE
RS290-1
Figure 2.
Cradle Roller Pin Assembly Wire Rope.
Table 2.
Materials List
Part Number (CAGEC)
National Stock Number
Quantity
Name
STRAND, WIRE
M83420/4-010 (81349)
4010-00-575-6233
As Required
SWAGING SLEEVE,
RS290-1 (86831)
4030-00-431-5536
2
WIRE ROPE
1.
Obtain all components required to fabricate cradle roller pin assemblies.
03/15/2011Rel(1.8)root(manuwp)wpno(M06016)
