TM 5-3990-264-13&P
0036
CRADLE ROLLER PIN ASSEMBLY WIRE ROPE - Continued
2.
Using a fine toothed hacksaw or suitable cutting device, cut strandwire 20 7/8 inches (53.02 cm) long.
3.
Slide strand wire through hole in component until strandwire comes through other side.
4.
Slide swaging sleeve onto strand wire until swaging sleeve bottoms against component and strand wire comes
through swaging sleeve.
5.
Crimp swaging sleeves to strandwire.
FRONT AND REAR TIE-DOWN CABLE ASSEMBLY WIRE ROPE
The front and rear tie-down cable assembly is used in 4 places. One strand wire is 1 inch (2.5cm) longer than the
other on each cable assembly. Crimped swaging sleeves are used to attach the strandwire to other components.
Each application requires two swaging sleeves.
CUTTING LENGTH
7 3/8 INCHES LONG (18.73 cm)
FINISHED LENGTH
6 1/2 INCHES LONG (16.51 cm)
CUTTING LENGTH
6 3/8 INCHES LONG (16.19 cm)
FINISHED LENGTH
5 1/2 INCHES LONG (13.97 cm)
STRAND WIRE
SWAGING
MS83420/4-010
1/4 Inch (.63 cm)
SLEEVE
RS290-1
Figure 3.
Front And Rear Tie-Down Cable Assembly Wire Rope.
Table 3.
Materials List
Name
Part Number (CAGEC)
National Stock Number
Quantity
STRAND, WIRE
M83420/4-010 (81349)
4010-00-575-6233
As Required
SWAGING SLEEVE,
RS290-1 (86831)
4030-00-431-5536
2
WIRE ROPE
1.
Obtain all components required to fabricate front and rear tie-down cable assemblies.
2.
Use a fine toothed hacksaw or suitable cutting device, cut strand wire 7 3/8 inches (18.73 cm) long or 6 3/8
inches (16.19 cm) long, depending on which wire is replaced.
3.
Slide strand wire through hole in component until strand wire comes through other side.
4.
Slide swaging sleeve onto strand wire until swaging sleeve bottoms against component and strand wire comes
through swaging sleeve.
03/15/2011Rel(1.8)root(manuwp)wpno(M06016)