TM 5-1940-321-13&P
Figure 5-8. Installing Diaphragm into Metal Valve Insert
Figure 5-9. Pulling Diaphragm Stem into Seated Position.
( 16 ) Reinstall the cleaned flat neoprene valve insert gasket or a new flat neoprene
valve insert gasket on the valve insert.
( 17 ) Apply a light coat of grease (OMC Tripleguard) evenly over the outer surface of
the male portion of the intercommunicating valve. Keep clean until assembly.
( 18 ) Put grease into the end of the 10mm deep-well nut driver socket and then
insert the locknut into the socket, small end first.
5-21