TM 5-3990-264-13&P
0017
GENERAL MAINTENANCE INSTRUCTIONS - Continued
GENERAL INSPECTION INSTRUCTIONS
Inspect for loose, missing or damaged parts.
Check for cracks, rust or pits, especially at weld points.
Inspect all parts to determine if they conform to the wear limits, fits and tolerances established.
GENERAL LUBRICATION INSTRUCTIONS
General lubrication needed before assembly or installation is called out in the maintenance procedures.
GENERAL INSTALLATION AND ASSEMBLY INSTRUCTIONS
Refer to notes or diagram made during disassembly to install precision matched or mated parts.
Torque bolts and nuts as required per Torque Limits.
Perform alignment and adjustment procedures as listed in the maintenance procedure. Complete any testing
required before the IBC is returned to operation.
Pay special attention to requirements for installing cotter pins and similar operations.
GENERAL TESTING INSTRUCTIONS
If needed, test procedures to verify proper operation will be called out in the maintenance procedure.
GENERAL ADJUSTMENT INSTRUCTIONS
No adjustments to the IBC are authorized at Field level.
END OF TASK
0017-3
03/15/2011Rel(1.8)root(maintwp)wpno(M06000)
