TM 5-1940-321-13&P
TIGHTNESS CHECK OF OUTBOARD ENGINE MOUNTING CLAMP SCREWS.
Materials Required ........ None
Tools Required .............. None
Parts Required .............. None
Parts to be Available ..... None
When outboard engines are installed, the tightness of the two outboard engine mounting clamp
screws must be checked daily unit personnel during periods of craft operation. Tighten each clamp screw
by hand until firmly tight. Do not use tools to tighten the clamps screws. The clamp screws are identified
in the outboard engine technical manual.
TIGHTNESS CHECK OF TRANSOM OUTBOARD ENGINE MOUNTING BOLTS.
Materials Required........ None
Tools Required............ Crescent Wrench, 12"
Parts Required............. None
Parts to be Available...... None
If the craft is equipped with crew clamps, verify that screw clamps are securely in place.
5-10. TIGHTNESS CHECK OF TRANSOM STRAPS.
Materials Required.......
None
Tools Required............
None
Parts Required............
None
Parts to be Available....
None
5-8